Difference between revisions of "CNC Mode"
From ArcoWiki
| (2 intermediate revisions by one other user not shown) | |||
| Line 4: | Line 4: | ||
*MODE/PROG,MAN: The CMM is in PROGRAMMED mode, the path is determined by the commands listed in the MEAS/ENDMES block and the inspection will be performed following the PTMEAS commands. | *MODE/PROG,MAN: The CMM is in PROGRAMMED mode, the path is determined by the commands listed in the MEAS/ENDMES block and the inspection will be performed following the PTMEAS commands. | ||
*MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands. | *MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands. | ||
| − | The custom canned cycles (Non-[[DMIS|Dmis]] standard) enhanced by ARCO, if set, are also executed in AUTO mode. | + | The [[custom canned cycles]] (Non-[[DMIS|Dmis]] standard) enhanced by ARCO, if set, are also executed in AUTO mode. |
| + | |||
| + | |||
| + | [[it:Modalità CNC]] | ||
| + | [[zh-cn:CNC模式]] | ||
| + | [[pt:Modo CNC]] | ||
| + | [[de:CNC-Modus]] | ||
| + | [[es:Modalità CNC]] | ||
| + | [[en:CNC Mode]] | ||
[[Category:Help_On_Line]] | [[Category:Help_On_Line]] | ||
Latest revision as of 10:03, 1 June 2018
CNC Mode is the state of the CMM that allows automatic movements.
The DMIS enhance two different attitudes based on the CNC Mode selected:
- MODE/PROG,MAN: The CMM is in PROGRAMMED mode, the path is determined by the commands listed in the MEAS/ENDMES block and the inspection will be performed following the PTMEAS commands.
- MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands.
The custom canned cycles (Non-Dmis standard) enhanced by ARCO, if set, are also executed in AUTO mode.
