Difference between revisions of "CNC Mode"
From ArcoWiki
m (3 revisions imported) |
|||
Line 5: | Line 5: | ||
*MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands. | *MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands. | ||
The [[custom canned cycles]] (Non-[[DMIS|Dmis]] standard) enhanced by ARCO, if set, are also executed in AUTO mode. | The [[custom canned cycles]] (Non-[[DMIS|Dmis]] standard) enhanced by ARCO, if set, are also executed in AUTO mode. | ||
+ | |||
+ | |||
+ | [[it:Modalità CNC]] | ||
+ | [[zh-cn:CNC模式]] | ||
+ | [[pt:Modo CNC]] | ||
+ | [[de:CNC-Modus]] | ||
+ | [[es:Modalità CNC]] | ||
+ | [[en:CNC Mode]] | ||
[[Category:Help_On_Line]] | [[Category:Help_On_Line]] |
Latest revision as of 10:03, 1 June 2018
CNC Mode is the state of the CMM that allows automatic movements.
The DMIS enhance two different attitudes based on the CNC Mode selected:
- MODE/PROG,MAN: The CMM is in PROGRAMMED mode, the path is determined by the commands listed in the MEAS/ENDMES block and the inspection will be performed following the PTMEAS commands.
- MODE/AUTO,PROG,MAN: The CMM is in AUTOMATIC mode, if the measuring feature has an canned cycle, then this will be performed even if the MEAS/ENDMES block contains PTMEAS commands.
The custom canned cycles (Non-Dmis standard) enhanced by ARCO, if set, are also executed in AUTO mode.