Difference between revisions of "Use of Points Projection during Best Fit"
From ArcoWiki
(Created page with "It has been added the possibility to limit the calculation of the alignment of BEST FIT and RPS only to selected surface when defining the nominal point. <br /> The default pr...") |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 3: | Line 3: | ||
Best Fit project on all model=1 //0 = projection only on the selected surface. | Best Fit project on all model=1 //0 = projection only on the selected surface. | ||
| + | [[it:Uso della proiezione punti durante la migliore vestibilità]] | ||
| + | [[zh-cn:最适合使用点投影]] | ||
| + | [[pt:Uso da projeção de pontos durante o melhor ajuste]] | ||
| + | [[de:Verwendung der Punktprojektion während der besten Anpassung]] | ||
| + | [[es:Uso de la proyección de puntos durante el mejor ajuste]] | ||
| + | [[en:Use of Points Projection during Best Fit]] | ||
[[Category:ReadMe3.5.100]] | [[Category:ReadMe3.5.100]] | ||
Latest revision as of 09:31, 29 June 2018
It has been added the possibility to limit the calculation of the alignment of BEST FIT and RPS only to selected surface when defining the nominal point.
The default provides projection of the points on whole model, to activate the limitation you must change, in WhiteStar.ini, the entry:
Best Fit project on all model=1 //0 = projection only on the selected surface.
