Difference between revisions of "Activation 5 Axes Mode"
From ArcoWiki
(Created page with "When "5 Axes" mode is enabled (default), the system executes or creates the program according to the correct syntax for handling multi axis. <br /> If, for execution reasons,...") |
|||
| Line 14: | Line 14: | ||
[[File:ReadMe_image025.jpg]]<br /> | [[File:ReadMe_image025.jpg]]<br /> | ||
| + | [[Category:Ph20]] | ||
[[Category:ReadMe3.5.100]] | [[Category:ReadMe3.5.100]] | ||
Revision as of 18:17, 10 September 2016
When "5 Axes" mode is enabled (default), the system executes or creates the program according to the correct syntax for handling multi axis.
If, for execution reasons, a program should be run in 3 axes standard mode, simply switch off the "5 Axes" mode from the options panel.
Warning!!
Disabling the 5 axes mode and execution of the 3 axes mode on an existing program, could create incompatibility of execution as the head could not reposition itself in the expected position.
Commands for the management of PH20 mode are:
