Difference between revisions of "Quick Calibration with Continuous Scanning Probes"
From ArcoWiki
| Line 1: | Line 1: | ||
| + | From the calibration Wizard it is now possible to select the "Point to Point" method of calibration for analogues probes.<br /> | ||
| + | This calibration procedure will '''renew only the probe offset without touching the analogue probe calibration matrix'''. | ||
| + | <br /> | ||
| + | <br /> | ||
| + | '''It not a full analogue probe calibration! | ||
| + | '''<br /> | ||
| + | To perform the "Point to Point" calibration on analogue probes from the wizard, it is just required to select the trigger mode from the probe selection page in the wizard.<br /> | ||
| + | <br /> | ||
| + | <br /> | ||
| + | |||
| + | [[File:CalibrationWizard_QuickCalibration.png]] | ||
[[it:Calibrazione rapida con sonde a scansione continua]] | [[it:Calibrazione rapida con sonde a scansione continua]] | ||
| Line 7: | Line 18: | ||
[[en:Quick Calibration with Continuous Scanning Probes]] | [[en:Quick Calibration with Continuous Scanning Probes]] | ||
| + | [[Category:Help_On_Line]] | ||
[[Category:ReadMe3.6]] | [[Category:ReadMe3.6]] | ||
Latest revision as of 11:24, 16 November 2018
From the calibration Wizard it is now possible to select the "Point to Point" method of calibration for analogues probes.
This calibration procedure will renew only the probe offset without touching the analogue probe calibration matrix.
It not a full analogue probe calibration!
To perform the "Point to Point" calibration on analogue probes from the wizard, it is just required to select the trigger mode from the probe selection page in the wizard.
