Difference between revisions of "Custom Canned Cycles for Automatic Feature Measurement"
From ArcoWiki
Line 23: | Line 23: | ||
| Pattern Helical Full || Example ||[[File:PatternHelicalFull.png|400px]] | | Pattern Helical Full || Example ||[[File:PatternHelicalFull.png|400px]] | ||
|- | |- | ||
− | | Pattern Helical Partial || Example ||[[ | + | | Pattern Helical Partial || Example ||[[File:PatternHelicalPartial.png|400px]] |
|- | |- | ||
| Pattern Section Full || Example ||[[File:PatternSectionFull.png|400px]] | | Pattern Section Full || Example ||[[File:PatternSectionFull.png|400px]] |
Revision as of 12:21, 17 May 2018
Introduction
From version 3.6 are present some "Non-Dmis" commands that allow to perform automatic measurement of features following a geometrical path instead being driven by regular PTMEAS/
commands.
The features whom those news cycles applies are:
- Circle
- Cylinder
- Planes
Activating the cycles
The automatic cycles can be set and activated by the measuring panel.
Opening one of the available features, a new icon is present, and this will show a dialog to define the different cycles.
Non- Dmis automatic cycle for Measurng cycles
Circle and Cylinders
For circles and cylinders features are available the following new automatic cycles: