Difference between revisions of "Automatic Visualization of Form Error Windows"
From ArcoWiki
| Line 1: | Line 1: | ||
In certain cases of manual inspection, it is necessary to have an '''automatic visualization of the form error windows''' avoid the selection of the dedicated icon in the Measuring Panel. | In certain cases of manual inspection, it is necessary to have an '''automatic visualization of the form error windows''' avoid the selection of the dedicated icon in the Measuring Panel. | ||
| − | This feature can be activate adding in the ''Whitestar.ini'' file the following line: | + | This feature can be activate adding in the ''[[Whitestar.ini]]'' file the following line: |
Auto display circle form error after this probed point=''numberOfPoints'' | Auto display circle form error after this probed point=''numberOfPoints'' | ||
Auto display cone form error after this probed point=''numberOfPoints'' | Auto display cone form error after this probed point=''numberOfPoints'' | ||
| Line 15: | Line 15: | ||
If the lines are missing, then the default is applied. | If the lines are missing, then the default is applied. | ||
The default setting is FEATURE DISABLED. | The default setting is FEATURE DISABLED. | ||
| + | |||
| + | [[Category:ReadMe3.6]] | ||
Revision as of 14:48, 2 September 2016
In certain cases of manual inspection, it is necessary to have an automatic visualization of the form error windows avoid the selection of the dedicated icon in the Measuring Panel.
This feature can be activate adding in the Whitestar.ini file the following line:
Auto display circle form error after this probed point=numberOfPoints Auto display cone form error after this probed point=numberOfPoints Auto display cylinder form error after this probed point=numberOfPoints Auto display plane form error after this probed point=numberOfPoints Auto display sphere form error after this probed point=numberOfPoints
where:
numberOfPoints: represents the number of points to betaken before the Form Error Panel is shown. If the number is set to "-1" the feature is disabled.
If the lines are missing, then the default is applied.
The default setting is FEATURE DISABLED.
