Automatic Visualization of Form Error Windows

In certain cases of manual inspection, it is necessary to have an automatic visualization of the form error windows avoid the selection of the dedicated icon in the Measuring Panel. This feature can be activate adding in the Whitestar.ini file the following line:

Auto display circle form error after this probed point=numberOfPoints
Auto display cone form error after this probed point=numberOfPoints
Auto display cylinder form error after this probed point=numberOfPoints
Auto display plane form error after this probed point=numberOfPoints
Auto display sphere form error after this probed point=numberOfPoints

where:

numberOfPoints: represents the number of points to betaken before the Form Error Panel is shown. If the number is set to "-1" the feature is disabled.

If the lines are missing, then the default is applied. The default setting is FEATURE DISABLED.