Correction of Linear Error With Scale Factors

From ArcoWiki
Revision as of 13:02, 26 August 2016 by Admin (talk | contribs) (Created page with "In addition to the full 24 parameter volumetric compensation of the CMM, it is possible to apply <b> Scale Factores</b> to correct some residual linear error. The factors shal...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

In addition to the full 24 parameter volumetric compensation of the CMM, it is possible to apply Scale Factores to correct some residual linear error. The factors shall be add to a figuration file as follow:

  1. Open the Folder ..\Data with Windows Explorer
  2. Open the File Machine.ini
  3. If not present, add in the bottom of the file the following lines:

[SFACTORS] 

SFX1=1
SFY1=1
SFZ1=1
SFX2=1
SFY2=1
SFZ2=1
  1. Type, for each axis and for arm, the scale correction to be applied
  2. Press File -> Save
  3. Press File -> Exit

THE CORRECTION OF THE LINEAR ERRORS WITH SCALE FACTOR IT IS NOT RECOMMENDED AND IT IS PREFERABLE TO USE A FULL ERROR MAPPING.

SCALE FACTOR CALCULATION CÁLCULO DE LOS FACTORES DE ESCALA. CALCULO DO FATOR DA ESCALA


Fattore di scala = valore misurato del blocco / valore nominale del blocco Scale factor= measured length of the gauge / nominal length of the block Factor de escala= valor medido del bloco / valor nominal del bloco Fator de escada= valor medido do bloco / valor nominal do bloco

Retrieved from "https://en.arcowiki.com/index.php?title=Correction_of_Linear_Error_With_Scale_Factors&oldid=179"