Gear Inspection Module
From ArcoWiki
The gear package in Arco allows the measurement of Spur and Helical gears with a CMM.
The measurement can be performed with:
- Point to Point (trigger) probe
- Continuous Scanning Probe
- PH20
By input the nominal data of a gear, Arco produce a program specifics for that gear automatically.
The preview allows the user to select all the metrologycal parameter for gear inspection such us:
- Limits and number of points for of the Involute
- Limits and number of points for if the Generatrix
- Safety radius for auto probe change
- Identification of the teeth to be measured
- Height of the gear
- Type of alignment within
- Current Reference System
- Plane and Cylinder
- Cylinder
- Synchronization of the tooth only
- Gear Program Definition
Based on the parameter ARCO creates a full program with all the points to be takes and the correct alignment procedure.
At the end of the execution is generated a PDF report that goes with the international standards, the parameters evaluated are:
- Profile Error (Fa,ffA,fHa)
- Flank Error (Fb,ffb,fHb)
- Quality Class
- Left and Right Pitch Error (fp,Fp)
- Thickness and Run-out (Ues,Aes,Les,Fr)
- Gear Report
